搜索资源列表
C8051
- C8051 800点12位AD转换 计算功率因素-C8051 800 12 AD converter power factor
APFC
- 有源功率因素校正APFC电路，采用电压外环+电流内环控制策略。经验证可很好实现功能-Active Power Factor Correction APFC circuit voltage outer the+ current inner loop control strategy. Proven good functions
00988679
- This paper presents a fully-digital-controlled shunt active filter for harmonic termination of a power distribution system. The main purpose of the active filter based on voltage detection is not to compensate for current harmonics but to damp
dbj
- 油田电泵井测试程序，主要测试电压、电流、功率，计算出功率因子，并用图形绘出-Oilfield pump wells test procedures, a major test voltage, current, power, power factor is calculated and plotted graphically
dbj
- 油田电潜泵井的检测，主要检测电流、电压、功率，以图形方式绘出；并算出功率因子-Oilfield electric submersible pump wells detection, detection current, voltage, power, plotted graphically calculated power factor
CS5463-PF
- CS5463 开发参考程序，可以读取功率因素等，并显示在四位数码管上。-CS5463 developed reference program, you can read the power factor, and displays on four digital tube.
APFC_basic_hysis
- 基本的boost PFC simulink仿真，带有功率因数测量。控制采用滞环控制，功率因数可达99 以上。-The basic boost PFC simulink simulation, with a power factor measurement. Control using hysteresis control, power factor up to 99 .
cos
- 单相电功率因数的计算方法，包括非正弦波等效法等计算不规则波形的功率因数-Calculation method of single-phase power factor, power factor, including non sine wave equivalent method, calculation of irregular wave
lilizixudianchi
- 本文设计了主电路参数并在MATLAB/Simuhnk环境下进行了仿真。本文还提 出了以MC9512D64为核心的双向DC/DC变换器控制板和控制器的硬件、软件的完 整的设计方案。充电采用恒流充电和恒压充电相结合的控制策略，实现单体电池 电压控制，提高了充放电控制性能和安全性。充放电系统样机测试结果表明:满 载时，系统效率80 以上，功率因数99 以上，谐波含量5 以下，满足设计要求， 验证了系统设计的可行性。 -The design parameters of the m
Lab-3-Demo-Files-W2013
- power factor correction
pfactor
- power factor improvement
8051-powerfactor-16x2lcd-4bit
- code for Power factor meter in 8051-mcu, 16x2 char lcd in 4-bit mode.
DoublymotorspeedcontrolPsimulation
- 感应电机双馈调速系统是一种性能优越的电力拖动控制系统，它不仅降低了功率 变换器的额定功率，而且能够通过调节转子电压的幅值、相位和频率来实现电机定子 侧功率因数的调节。 -The doubly-fed speed control system of induction motor is a superior performance of the electric drive control system, it not only reduces the rated powe
01355492
- Direct Control Method for Matrix Converters with Input Power Factor Regulation
chengxu
- 测功率因数角，用于无功补偿，前期工作，电机无功补偿控制程序。-Measured power factor angle for reactive power compensation, the preliminary work, the motor reactive power compensation control program.
Wind-turbine-blades-design
- 本文利用MATLAB的遗传算法工具箱，对弦长和扭角沿风力机展向分布进行优化，得到设计工况下的最优叶片设计。目标函数是设计工况下基于动量叶素理论和Glauert等修正所得出的功率系数。在设计工况下得到的设计结果，其功率系数在一定的风速范围内都能保持一个较高的数值，同时其有效攻角分布大致都在所选翼型的升力与阻力系数的比值最大处，与理论相符合。其结果说明该优化实际的有效性。-In this paper, the use of MATLAB genetic algorithm toolbox, chor
pfc
- power factor control inveretr
A-DSP-Based-On-Line-UPS-
- 在开关电源或者UPS领域，基于DSP的低成本APFC设计方案-A Low Cost Design Solution- DSP Based Active Power Factor Corrector for SMPS/ UPS( Single Phase)
powerfactorcorrection
- this a simulink model..POWER FACTOR CORRECTION OF INDUCTIVE LOAD USING FC-TCR COMPENSATOR-this is a simulink model..POWER FACTOR CORRECTION OF INDUCTIVE LOAD USING FC-TCR COMPENSATOR
statom_3_phase
- by ankush laddha。This system is active front end rectifier. It keeps the DC link at reference value, 400V in this case, even if load is suddenly changes. Also power factor is controllable so can act as STATCOM too. Control is based on synchronous fra